Hi Sana, You can very well use setdest Regards, Jalaja On Wed, May 4, 2016 at 7:56 AM, Sana Shaikh <[log in to unmask]> wrote: > How can i move an underwater sensor node to a specific destination by > specifying coordinates? > Is there any command like the one we use for a normal WSN: > *$ns at $time $node setdest <x2> <y2> <speed>* > -- ************************ *CAUTION - Disclaimer* *************************************** This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely for the use of the addressee(s). If you are not the intended recipient, please notify the sender by e-mail and delete the original message. Further, you are not to copy, disclose, or distribute this e-mail or its contents to any other person and any such actions are unlawful. This e-mail may contain viruses. RIT has taken every reasonable precaution to minimize this risk, but is not liable for any damage you may sustain as a result of any virus in this e-mail. You should carry out your own virus checks before opening the e-mail or attachment. *Please do not print this email unless it is absolutely necessary. Lets' go GREEN.* *Rajiv Gandhi Institute of Technology* ******** End of Disclaimer **********************